Hei, beim Botten einer Siemens RX300 S3 wird [42949391.890000] megasas: 00.00.02.04 Fri Feb 03 14:31:44 PST 2006 [42949391.890000] megasas: 0x1000:0x0411:0x1734:0x1081: bus 2:slot 14:func 0 [42949391.890000] ACPI: PCI Interrupt 0000:02:0e.0[A] -> GSI 38 (level, low) -> IRQ 98 [42949391.950000] scsi6 : LSI Logic SAS based MegaRAID driver [42949391.950000] Vendor: SEAGATE Model: ST373355SS Rev: 1751 [42949391.950000] Type: Direct-Access ANSI SCSI revision: 05 [42949391.950000] Vendor: SEAGATE Model: ST373355SS Rev: 1751 [42949391.950000] Type: Direct-Access ANSI SCSI revision: 05 [42949391.960000] Vendor: LSI Model: MegaRAID SAS RMB Rev: 1.02 [42949391.960000] Type: Direct-Access ANSI SCSI revision: 05 [42949391.970000] SCSI device sda: 142278656 512-byte hdwr sectors (72847 MB) [42949391.970000] sda: test WP failed, assume Write Enabled [42949391.970000] sda: asking for cache data failed [42949391.970000] sda: assuming drive cache: write through [42949391.970000] SCSI device sda: 142278656 512-byte hdwr sectors (72847 MB) [42949391.970000] sda: test WP failed, assume Write Enabled [42949391.970000] sda: asking for cache data failed [42949391.970000] sda: assuming drive cache: write through [42949391.970000] sda: sda1 sda2 < sda5 > [42949391.980000] sd 6:2:0:0: Attached scsi disk sda