Hi LUGs, Ich habe einen AGFA SNAPSCAN 1236s und einen LSI Logic / Symbios Logic (formerly NCR) 53c810 SCSI Controller. Mein SCSI CD-Writer funktioniert, der Scanner aber nicht, ich bekomme folgenden Fehler: Jan 20 17:49:53 martin kernel: ncr53c810a-0-<5,*>: target did not report SYNC. Jan 20 17:49:54 martin kernel: ncr53c810a-0-<5,0>: extraneous data discarded. Jan 20 17:49:54 martin kernel: ncr53c810a-0-<5,0>: COMMAND FAILED (89 0) @c2fa9800. Ein alter Highscreen SCSI Scanner hat übrigens funktioniert. Habt ihr eine Idee was man da machen kann ? /var/log/messages: Jan 20 17:49:33 martin kernel: PCI: Found IRQ 9 for device 00:0a.0 Jan 20 17:49:33 martin kernel: PCI: Sharing IRQ 9 with 00:0e.0 Jan 20 17:49:33 martin kernel: ncr53c8xx: at PCI bus 0, device 10, function 0 Jan 20 17:49:33 martin kernel: ncr53c8xx: 53c810a detected Jan 20 17:49:33 martin kernel: ncr53c810a-0: rev 0x23 on pci bus 0 device 10 function 0 irq 9 Jan 20 17:49:33 martin kernel: ncr53c810a-0: ID 7, Fast-10, Parity Checking Jan 20 17:49:33 martin kernel: scsi0 : ncr53c8xx-3.4.3b-20010512 Jan 20 17:49:36 martin kernel: Vendor: TEAC Model: CD-R58S Rev: 1.0K Jan 20 17:49:36 martin kernel: Type: CD-ROM ANSI SCSI revision : 02 Jan 20 17:49:37 martin kernel: Vendor: AGFA Model: SNAPSCAN 1236 Rev: 1.50 Jan 20 17:49:37 martin kernel: Type: Scanner ANSI SCSI revision : 02 Jan 20 17:49:38 martin kernel: Attached scsi CD-ROM sr0 at scsi0, channel 0, id 2, lun 0 Jan 20 17:49:38 martin kernel: Attached scsi generic sg1 at scsi0, channel 0, id 5, lun 0, ty pe 6 Jan 20 17:49:38 martin kernel: ncr53c810a-0-<2,*>: FAST-10 SCSI 10.0 MB/s (100 ns, offset 8) Jan 20 17:49:38 martin kernel: sr0: scsi3-mmc drive: 24x/24x writer cd/rw xa/form2 cdda tray Jan 20 17:49:53 martin kernel: ncr53c810a-0-<5,*>: target did not report SYNC. Jan 20 17:49:54 martin kernel: ncr53c810a-0-<5,0>: extraneous data discarded. Jan 20 17:49:54 martin kernel: ncr53c810a-0-<5,0>: COMMAND FAILED (89 0) @c2fa9800. Danke & Gruß, Martin Herweg